Removing The Chassis Intrusion Switch - Desktop; Freeing The Chassis Intrusion Switch - Desktop - NEC POWERMATE ES 5200 Service Manual

Removing the Chassis Intrusion Switch — Desktop
Remove the chassis intrusion switch from a desktop system by following these
steps.
1. Turn off the system and disconnect the system power cord.
2. Ensure that all external cables are disconnected from the front and rear of
the system.
3. Remove the system unit cover (see "Removing the Small Desktop or
Desktop Cover").
4. Remove the plastic collar from the intrusion switch on the riser board (see
in the following figure).
5. Remove the switch from its connector on the riser board (see
following figure).
Freeing the Chassis Intrusion Switch — Desktop
3-74 Disassembly and Reassembly
1
in the
2