Table of Contents
Advertisement
Replacing the Left Side Brace
Follow these steps to replace the left side brace in the desktop system.
1. Hold the brace with the hooked tab on your right. Angle the brace so the left
end is about four inches farther away than the right. (See the following
figure.)
2. Place the hooked tab into the slot on the front edge of the chassis.
3. Once the right end of the brace is hooked in place, slide the left end
horizontally toward the left rear corner of the chassis.
4. Align the screw holes in the left end of the brace and the left rear corner of
the chassis.
5. Secure the brace with the screw.
A – Left Side Brace
B – Left Side Bracket
Positioning the Left Side Brace — Desktop
C – Hooked Tab
D – Front of Chassis
Disassembly and Reassembly 3-63
Advertisement
Table of Contents
