Table of Contents
Advertisement
Diskette Drive Removal and Installation
The following sections describe how to remove and install a 3 1/2-inch diskette
drive.
Removing a Diskette Drive — Small Desktop
Use the following procedure to remove a diskette drive from a 3 1/2-inch
accessible device bay in a small desktop system.
1. Remove the system unit cover (see "Removing the Small Desktop or
Desktop Cover").
2. Remove the front panel (see "Removing the Front Panel — Small
Desktop").
3. Disconnect and label the diskette drive cables.
4. Remove the two screws on the right side of the drive (see the following
figure).
Removing Diskette Drive Screws — Small Desktop
A – Diskette Drive
5. Pull the drive out of the drive bay, making sure that the offset screw on the
left side of the drive clears the catch on the left side of the drive bracket.
6. If you are installing a new drive, see "Installing a Diskette Drive — Small
Desktop."
B – Diskette Drive Screws
Disassembly and Reassembly 3-21
Advertisement
Table of Contents
Need help?
Do you have a question about the POWERMATE ES 5200 and is the answer not in the manual?
Questions and answers