Table of Contents
Advertisement
6. Insert the device the rest of the way into the device bay, making sure that the
locking tabs on the sides of the drive engage the brackets on each side of the
device bay.
7. Secure the device to the bay with two screws (see the first figure in
"Removing a 5 1/4-Inch Device — Small Desktop or Desktop").
8. Replace the front panel.
T
For a small desktop system see "Replacing the Front Panel — Small
Desktop."
T
For a desktop system, see "Replacing the Front Panel — Desktop."
9. Replace the system unit cover (see "Replacing the Small Desktop or
Desktop Cover").
10. Run the Setup program to set the new configuration (see "CMOS Setup
Utility" in Section 2).
Removing a 5 1/4-Inch Device — Minitower
Use the following procedure to remove a 5 1/4-inch device from a 5 1/4-inch
accessible device bay.
1. Remove the left side cover (see "Removing the Minitower Side Covers").
2. Remove the front panel (see "Removing the Front Panel — Minitower").
3. Label and disconnect the device cables. If necessary, remove the top cover
for access to the connectors (see "Removing the Minitower Top Cover").
4. Remove the two screws on the left side of the device (see the following
figure).
Locating 5 1/4-Inch Device Screws — Minitower
A – Screws (2)
3-28 Disassembly and Reassembly
B – Device
Advertisement
Table of Contents
