Changing Network Settings - NEC POWERMATE ES 5200 Service Manual

Changing Network Settings

All systems are configured with the NetBEUI and NWLink protocols enabled.
However, before you connect a system to your network you might need to:
T
enable a different network protocol
T
disable unneeded protocols for enhanced system performance
T
add or change network, domain, and gateway information.
The following procedure describes how to disable the NetBEUI and NWLink
protocols, enable TCP/IP, and provide network, domain, and gateway
information. (If a different protocol is enabled, the menu choices might differ
from those described in the procedure.)
1. From the Windows desktop, click
and click
2. Double click the
3. Click the
are loaded:
NetBEUI Protocol
NWLink IPXSPX-Compatible Transport
NWLink NetBIOS
4. Highlight
warning window appears asking for confirmation to continue.
5. Click
Yes
NetBIOS lines disappear from the Protocols display.
6. Repeat steps 4 and 5 to remove the
7. Click
Add
8. Highlight
appears. If there is a DHCP server on the network, click
click
No
9. Change the path in the window to
window appears. If Yes was clicked in step 8, skip to step 16. If No was
clicked in step 8, the Windows Setup window appears.
10. Click
Close
11. Fill in the
"Specify an IP address" area.
12. Click the
13. Click the
14. Click the
15. Click the
16. Click
OK
.
Control Panel
icon in the Control Panel window.
Network
tab. In the Protocols display, the following protocols
Protocols
NWLink IPXSPX-Compatible Transport
. The NWLink IPXSPX-Compatible Transport and NWLink
. The Select Network Protocol window appears.
TCP/IP Protocol and click
.
. The Microsoft TCP/IP Properties Box appears.
, the
IP Address Subnet Mask
DNS tab and enter the host and domain name in the DNS display.
tab and change the Computer Name if appropriate.
Identification
tab and enter the WINS address if appropriate.
WINS
tab and enable IP forwarding if appropriate.
Routing
. When prompted to restart the system, click
on the taskbar, point to
Start
and click
Protocol.
NetBEUI
OK . The TCP/IP Setup window
. Click
C:\I386 Continue
, and the
Default Gateway
Yes
Release Notes A-7
,
Settings
Remove . A
Yes ; otherwise
. The Network
in the
.