Installing Or Removing A 5.25-Inch Device; Adding A 5.25-Inch Device - NEC I-Select TW100 User Manual

I-Select TS100 / I-Select TW100 User Guide - Upgrading Your System

Installing or Removing a 5.25-inch Device

This section of the chapter describes how to add and remove 5.25-inch devices. You
can install a DVD-ROM/ COMBO DVD-ROM CD-RW/ DVD+R9 Drive, tape backup
unit, or other 5-25 inch devices in the additional 5.25-inch bay. See the installation
instructions included with those items for specific installation information. Before
installing a 5.25-inch device, read section "Preparing the Device" on page 4-33.

Adding a 5.25-inch Device

1. Remove the right side door. See "Removing the Right Side Door" on page 4-4.
2. Remove the front panel. See "Removing the Front Panel" on page 4-6.
3. From the inside of the chassis, push on the desired slot cache with your left hand
and hold it with your right hand outside the chassis.
4. Pivot the cache until it gets released from the frame.
is normal.
5. Take two slide rails marked as "CD-ROM". Slide rails come with the system in a
plastic bag.
6. Attach the slide rails to the upper holes on both side of the 5.25-inch device.
7. Slide in the 5.25-inch device until hearing a click sound.
8. Connect the data cable to the device with the marked edge toward pin 1 of the
drive. See "Cabling the Device" on page 4-27.
9. Connect the power cable to the drive. See "Cabling the Device" on page 4-27.
10. Replace the front panel. See "Replacing the Front Panel" on page 4-6.
11. Replace the right side door. See "Replacing the Right Side Door" on page 4-5.
additional device. For additional information, refer to the
'Configuring your system' chapter.
Note: The two tabs that hold the cache actually break: this
Figure 4 - 8 : Attaching the Slide Rails
Figure 4 - 9 : Installing the 5.25-inch device
Note: Modify the BIOS Setup program to recognise the
4 - 10