Installing A Dimm; Releasing A Dimm - NEC POWERMATE ES 5200 Service Manual

3. Press the plastic clips at the outer edges of the socket away from the memory
module (see the following figure). This ejects the DIMM from the socket.
A – Plastic Clip
4. If installing a DIMM, see the next section, "Installing a DIMM."
5. If you are not installing a DIMM, slide the system board into the chassis.
T
For a small desktop system, see "Installing the System Board — Small
Desktop."
T
For a desktop system, see "Installing the System Board — Desktop."
T
For a minitower system, see "Installing the System Board —
Minitower."
6. Replace the cover(s):
T
For a small desktop or desktop system, see "Replacing the Small
Desktop or Desktop Cover."
T
For a minitower system, see "Replacing the Minitower Side Covers."

Installing a DIMM

Install a memory module by performing the following steps.
1. Remove the system board to access DIMM sockets.
T
For a small desktop system, see "Removing the System Board — Small
Desktop."
T
For a desktop system, see "Removing the System Board — Desktop."
T
For a minitower system, see "Removing the System Board —
Minitower."
2. If you need to remove a currently installed memory module, see "Removing
a DIMM."

Releasing a DIMM

Disassembly and Reassembly 3-37