Table of Contents
Advertisement
A – Blank Panel Tabs
7. Remove the metallic shield from the selected chassis bay by pulling it off
the chassis. Save it for later use if you decide to remove and not replace the
device.
8. Install the device (see "Installing a 5 1/4-Inch Device — Minitower").
Replacing the Front Panel — Minitower
Replace the front panel as follows.
Note:
5 1/4-inch device from your system and didn't replace it, you
need to cover the opening in the chassis and the front panel.
1. If necessary replace the metallic shield by pressing it into place over the bay.
2. Replace the blank plastic panel if necessary. Press the blank panel into the
inside of the front panel (over the empty bay). Press until the four tabs lock
the panel in place.
3. Align the four front panel plugs and the two locking tabs with the mounting
holes in the front of the system unit (see the figure in "Removing the Front
Panel — Minitower").
4. Insert the two locking tabs into the holes at the bottom of the chassis then
evenly press the front panel into position until the plugs lock the panel in
place.
5. Replace the left side cover (see "Replacing the Minitower Side Covers").
3-20 Disassembly and Reassembly
Locating the Blank Panel Tabs — Minitower
Before replacing the front panel, if you removed a
Advertisement
Table of Contents
