Table of Contents
Advertisement
Management Guide
TigerAccess™ EE
6.2
6.2.1
6.2.2
!
SMC7824M/VSW
Configuration Management
You can verify if the system configurations are correct and save them in the system. This
section contains the following functions.
Displaying System Configuration
•
Writing System Configuration
•
Auto-Saving
•
System Configuration File
•
Restoring Default Configuration
•
Displaying System Configuration
To display the current running configuration of the system, use the following command.
Command
show running-config
show running-config {admin-flow | admin-
policy | flow | arp | bridge | dns | full | host-
name | login | qos | rmon-alarm | rmon-event |
rmon-history | policer | policy | snmp | syslog |
time-out | time-zone}
The following is an example to display the configuration of the syslog.
SWITCH# show running-config syslog
!
syslog start
syslog output info local volatile
syslog output info local non-volatile
!
SWITCH#
Writing System Configuration
If you change the configuration of the system, you need to save the changes in the sys-
tem flash memory.
To write a current running configuration, use the following command.
Command
write memory
write terminal
When you use the write memory command, make sure there is no key input until [OK]
message appears.
Mode
Shows a configuration of the system.
All
Shows a configuration of the system with
the specific option.
Mode
Writes a current running configuration in the system
All
flash memory.
Shows a current running configuration on the terminal.
Enable
(alias to the show running-config command)
Description
Description
CLI
123
Advertisement
Table of Contents
