Ham-Band - SMC Networks 7824M/VSW - annexe 1 Manual

Management Guide
TigerAccess™ EE
5.3.2.10
!
!
SMC7824M/VSW
To enable/disable TCM of VDSL line port, use the following command. .
Command
lre PORTS tcm {enable | disable}
To display configured TCM, use the following command.
Command
show lre tcm [PORTS]

Ham-band

The bandwidth that VDSL port of switch includes Ham band. It causes interruption in
VDSL line. To prevent this interruption, you can configure not to use Ham band in band-
width.
To disable specified Ham band for a port, use the following command.
Command
lre PORTS ham-band {band1ㅣband2ㅣband3
ㅣband4ㅣband5ㅣband6ㅣband7ㅣband8ㅣ
band9ㅣband10ㅣband11ㅣband12ㅣband13ㅣ
band14ㅣband15ㅣband16ㅣband17ㅣband18
ㅣband19ㅣband20ㅣband21}
If you configure Ham band at VDSL port, it is applied to all ports.
To enable Ham band of a port, use the following command.
Command
no lre PORTS ham-band {all |
BAND NO}
To confirm disabled Ham band, use the following command
Command
show lre ham-band [PORTS]
You can configure plural Ham bands, up to thirteen bands. For example, if you input
band1, band2, band3 in order, then three Ham bands.
Mode
Bridge Configures TCM (default: enable)
Mode
Enable/Global/Bridge Shows the configured TCM.
Mode
Bridge
Mode
Bridge Enables disabled Ham-band.
Mode
Enable/Global/Bridge
Description
Description
Description
Disables specified Ham band.
Description
Description
Shows disabled Ham-band.
CLI
87