Port Traffic; Fan Operation - SMC Networks 7824M/VSW - annexe 1 Manual

Management Guide
TigerAccess™ EE
6.1.13.2
i
6.1.13.3
SMC7824M/VSW
To show the configured threshold of CPU load, use the following command.
Command
show cpuload
show cpu-trueload

Port Traffic

To set the threshold of port traffic, use the following command.
Command
threshold port
THRESHOLD {5 | 60 | 600} {rx |
tx}
no threshold port PORTS {rx |
tx}
The threshold of the port is set to the maximum rate of the port as a default.
To set a timer to block incoming traffic through specific port, use the following command.
Command
threshold port PORTS
timer <10-3600>
no threshold port PORTS block
To show the configured threshold of port traffic, use the following command.
Command
show port threshold

Fan Operation

The system fan will operate depending on measured system temperature. To set the
threshold of fan operation, use the following command.
Command
threshold fan START-TEMP
STOP-TEMP
no threshold fan
Mode
Shows the configured threshold of CPU load.
Enable
Global
Shows the CPU usage every 5 seconds during current
Bridge
10 minutes.
Mode
Sets the threshold of port traffic.
PORTS
PORTS: port number
THRESHOLD: threshold value (unit: kbps)
Global
5 | 60 | 600: time interval (unit: second)
Deletes the configured threshold of port traffic.
Mode
Set a timer to block the traffic which goes over its
block
threshold.
Global
10-3600: expire timer (unit: second)
Deletes the configured threshold of port traffic.
Mode
Enable/Global/Bridge
Mode
Sets the threshold of fan operation in the unit of Cel-
sius (°C).
START-TEMP: starts fan operation. (default: 30)
Global
STOP-TEMP: stops fan operation. (default: 0)
Deletes a configured threshold of fan operation.
Description
Description
Description
Description
Shows the configured threshold of port
traffic.
Description
CLI
119