Reinitiating Delay; Displaying Lldp Configuration - SMC Networks 7824M/VSW - annexe 1 Manual

CLI
7.3.6
7.3.7
154

Reinitiating Delay

To configure the interval time of enabling LLDP frame after configuring LLDP operation
type, use the following command.
Command
lldp reinitdelay <1-10>
To configure delay time of transmitting LLDP frame, use the following command.
Command
lldp txdelay <1-8192>

Displaying LLDP Configuration

To display LLDP configuration, use the following command.
Command
show lldp config [PORTS]
show lldp remote [PORTS]
show lldp statistics [PORTS]
To delete an accumulated statistics on the port, use the following command.
Command
clear lldp statistics [PORTS]
The following is the sample output of the show lldp config command.
SWITCH(config)# show lldp config 1-2
GLOBL:
-----------------------------------------------------------------------
MsgTxInterval
MsgTxHold
ReInitDelay
TxDelay
-----------------------------------------------------------------------
PORTS active adminStat|
1: disable Tx<->Rx|
2: disable Tx<->Rx|
SWITCH(config)#
Mode
Configures the interval time of enabling LLDP frame
Bridge from the time of configuring not to process LLDP
frame. (default: 2)
Mode
Configures delay time of transmitting LLDP frame.
Bridge
(default: 2)
Mode
Shows LLDP configuration.
Enable
Global Show statistics for remote entries.
Bridge
Shows LLDP operation and statistics.
Mode
Enable
Deletes an accumulated statistics on the port.
Global
Bridge
= 30
= 4 => txTTL = 120
= 2
= 2
mgmtAddress|optTLVs
none|
none|
Management Guide
TigerAccess™ EE
Description
Description
Description
Description
SMC7824M/VSW