Configuring Agc (Auto Gain Control) - SMC Networks 7824M/VSW - annexe 1 Manual

CLI
i
5.3.5.4
106
Step 4
Exit from FTP server.
ftp> bye
221 Goodbye.
SWITCH#
Step 5
After exiting from FTP, change the name of system image file of CPE stored in this switch
into the single file name.
To change into the single file name, please use the following command.
Command
store cpe-nos FILENAME
The following is and example to change the name of CPE files into single file name after
exiting from FTP.
ftp> exit
221 Goodbye.
SWITCH# store cpe-nos cpe
SWITCH#
Input the port number connected to CPE which is supposed to install system image.
Step 6
Install the system image file to the CPE.
Command
cpe nos-download PORTS
Step 7
Reboot the CPE in which new system image file is installed.

Configuring AGC (Auto Gain Control)

AGC is the function of lengthen the communication distance. By using this function, it is
possible to communicate in 140m. Therefore, it is better to use this function in the case
the distance from CPE to the user is over 100m. To enable AGC in CPE, use the following
command.
Command
cpe agc-on PORTS
Mode
Enable Stores system image file in CPE.
Mode
Installs the system image file to a CPE, which is con-
Bridge
nected through a port.
Mode
Bridge Enables AGC in CPE.
Management Guide
TigerAccess™ EE
Description
Description
Description
SMC7824M/VSW