SMC Networks 7824M/VSW - annexe 1 Manual page 101

CLI
!
i
!
100
The following is an example of enabling configuration
SWITCH(bridge-alarm-config-profile[TEST])# active
SWITCH(bridge-alarm-config-profile[TEST])# show running-config
(omitted)
alarm-config-profile TEST
thresh-15min-lofs 300
thresh-15min-loss 300
thresh-15min-lols 300
thresh-15min-ess 300
thresh-15min-sess 300
thresh-15min-uass 300
active
(omitted)
SWITCH(bridge-line-config-profile[TEST])#
Unless you enable configured profiles, they will not be applied although you apply them to
ports.
After you configure and enable profile, if you change the configuration, then it will be
automatically disabled. Therefore you have to enable it with "active" whenever you
change configurations.
Step 4
Save Profile after going back to Global configuration mode or Enable mode.
SWITCH(config)# write memory
Building configuration...
[OK]
SWITCH(config)#
Besides, when switch is been stacking, Alarm config profile configured in Master will be
automatically configured in Slave. Although it is configured before stacking, Master's con-
figuration will be configured in Slave by finding any difference. However, you have to save
the configuration of Slave with using "write memory". Unless you do it, the configuration
will be deleted and the above procedure will be repeated.
With enabled stacking, config profile of Master will be configured in Slave. it is impossible
to configure alarm config profile in Slave.
Step 5
Apply Profile to port. Use the following command
Command
alarm-config-profile NAME add PORTS
The following is an example of applying Profile named TEST to port 1.
SWITCH(bridge)# alarm-config-profile TEST add 1
SWITCH(bridge)#
Mode Description
Bridge Applies Profile to port
Management Guide
TigerAccess™ EE
SMC7824M/VSW