Table of Contents
Advertisement
CLI
5.3.5
i
!
5.3.5.1
5.3.5.2
102
Configuring CPE
You can reset CPE used when switch and check state of CPE.
"PORTS" at CPE configuration command is VDSL port number connected specified CPE.
The below description is only for this switch, in which module is installed in DMT modula-
tion.
This chapter describes the following lists.
Modem Port Reset
•
Installing System Image of CPE
•
•
Installing CPE System Image File in Slave
•
Configuring AGC (Auto Gain Control)
Checking Length of Cable between CPE and CO
•
Auto-negotiation of CPE
•
Transmit Rate of CPE
•
Duplex mode of CPE
•
Auto Upgrade of CPE Image
•
Displaying CPE Status
•
Modem Port Reset
When connection state of this switch and network is not normal, there may be some prob-
lem in modem port connection of CPE In this case, you can reset modem port of CPE. To
reset modem port of CPE, use the following command.
Command
cpe modem-reset PORTS
The following is an example of resetting modem port of CPE connected to port 1
SWITCH(bridge)# cpe modem-reset 1
SWITCH(bridge)#
Installing System Image of CPE
You can install system image of CPE using command in this switch. After changing the
name of system image file into that of single-file which is configured in internal system,
install system image file in CPE. Perform the below steps to install system image file in
CPE.
Step 1
Connect to FTP to store the CPE system image file in this switch.
Mode
Bridge
Resets modem port of CPE.
Management Guide
TigerAccess™ EE
Description
SMC7824M/VSW
Advertisement
Table of Contents
