Applying And Modifying Policer; Rule Action; Policy Creation - SMC Networks 7824M/VSW - annexe 1 Manual

CLI
7.6.3.5
7.6.4
7.6.4.1
i
178
To display configured size of a token bucket, use the following command.
Command
show qos max-bucketSize port
show qos max-bucketSize port-
queue PORTS

Applying and modifying Policer

After configuring a policer using the above commands, apply it to the system with the fol-
lowing command. If you do not apply the policer to the system, all specified configurations
on Policer Configuration mode will be lost. To save and apply a policer, use the following
command.
Command
apply
To modify a policer, use the following command.
Command
policer NAME modify

Rule Action

Policy Creation

To configure a policy, you need to open Policy Configuration mode first. To open Policy
Configuration mode, use the following command.
Command
policy NAME create
After opening Policy Configuration mode, the prompt changes from SWITCH(config)# to
SWITCH(config-policy[NAME])#.
To delete configured policy or all policies, use the following command.
Command
no policy NAME
no policy all
After opening Policy Configuration mode, a policy can be configured by user. The rule
priority and rule action(s) can be configured for each policy.
The policy name must be unique. Its size is limited to 32 significant characters.
•
Mode
Shows the token bucket size of all ports
Global
Shows the token bucket size of each queue for port
Mode
Policer Applies a policer to the system.
Mode
Global Modifies a policer, enter a policer name.
Mode
Creates a policy and opens Policy Configuration mode.
Global
NAME: policy name.
Mode
Deletes a policy, enter a policy name.
Global
Deletes all policies.
Management Guide
TigerAccess™ EE
Description
Description
Description
Description
Description
SMC7824M/VSW