Snmp Trap Host; Snmp Trap In Event Mode - SMC Networks 7824M/VSW - annexe 1 Manual

CLI
7.1.8.2
!
i i
7.1.8.3
140

SNMP Trap Host

To set an SNMP trap host, use the following command.
Command
snmp trap-host A.B.C.D [COMMUNITY]
snmp trap2-host A.B.C.D [COMMUNITY]
snmp inform-trap-host A.B.C.D [COMMUNITY]
To delete a specified SNMP trap host, use the following command.
Command
no snmp trap-host A.B.C.D
no snmp trap2-host A.B.C.D
no snmp inform-trap-host
A.B.C.D
If you manage the system via the ACI-E, you should specify an SNMP trap v2 host with
the snmp trap2-host command.
You can set maximum 16 SNMP trap hosts with inputting one by one.
The following is an example of setting an SNMP trap host.
SWITCH(config)# snmp trap-host 10.1.1.3
SWITCH(config)# snmp trap-host 20.1.1.5
SWITCH(config)# snmp trap-host 30.1.1.2
SWITCH(config)#

SNMP Trap in Event Mode

The system provides various kind of SNMP trap, but it may inefficiently work if all these
trap messages are sent very frequently. Therefore, you can select each SNMP trap sent
to an SNMP trap host.
auth-fail is shown to inform wrong community is input when user trying to access
•
to SNMP inputs wrong community.
• cold-start is shown when SNMP agent is turned off and restarts again.
• link-up/down is shown when network of port specified by user is disconnected, or
when the network is connected again.
mem-threshold is shown when memory usage exceeds the threshold specified by
•
user. Also, when memory usage falls below the threshold, the trap message will be
shown to notify it.
cpu-threshold is shown when CPU utilization exceeds the threshold specified by
•
user. Also, when CPU load falls below the threshold, trap message will be shown to
notify it.
• port-threshold is shown when the port traffic exceeds the threshold configured by
user. Also, when port traffic falls below the threshold, trap message will be shown.
temp-threshold is shown when the system temperature exceeds the thresh-old con-
•
Mode
Specifies an SNMP trap v1 host.
Global
Specifies an SNMP trap v2 host.
Specifies an SNMP inform trap host.
Mode
Deletes a specified SNMP trap v1 host.
Deletes a specified SNMP trap v2 host.
Global
Deletes a specified SNMP inform trap host.
Management Guide
TigerAccess™ EE
Description
Description
SMC7824M/VSW