Disabling Snmp Trap - SMC Networks 7824M/VSW - annexe 1 Manual

Management Guide
TigerAccess™ EE
i
7.1.8.4
SMC7824M/VSW
figured by user. Also, when system temperature falls below the threshold, trap mes-
sage will be shown.
dhcp-lease is shown when no more IP address is left in the DHCP pool. Even if this
•
occurs only in one DHCP pool of several pools, this trap message will be shown.
fan/ module is shown when there is any status-change of fan and module.
•
The system is configured to send all the SNMP traps by default.
To enable the SNMP trap, use the following command.
Command
snmp trap auth-fail
snmp trap cold-start
snmp trap link-up
[NODE]
snmp trap link-down PORTS
[NODE]
snmp trap mem-threshold
snmp trap cpu-threshold
snmp trap port-threshold
snmp trap temp-threshold
snmp trap dhcp-lease
snmp trap fan
snmp trap module
snmp trap pps-control

Disabling SNMP Trap

To disable the SNMP trap, use the following command.
Command
no snmp trap auth-fail
no snmp trap cold-start
no snmp trap link-up PORTS [NODE]
no snmp trap link-down PORTS [NODE]
Mode
Configures the system to send SNMP trap when SNMP
authentication is fail.
Configures the system to send SNMP trap when SNMP
agent restarts.
PORTS Configures the system to send SNMP trap when a port
is connected to network.
Configures the system to send SNMP trap when a port
is disconnected from network.
Configures the system to send SNMP trap when mem-
ory usage exceeds or falls below the threshold.
Configures the system to send SNMP trap when CPU
load exceeds or falls below the threshold.
Global
Configures the system to send SNMP trap when the
port traffic exceeds or falls below the threshold.
Configures the system to send SNMP trap when sys-
tem temperature exceeds or falls below the threshold.
Configures the system to send SNMP trap when no
more IP address is left in the DHCP pool.
Configures the system to send SNMP trap when the
fan begins to operate or stops.
Configures the system to send SNMP trap when there
is any problem in module.
Configures the system to send SNMP trap when the
number of packets per second exceeds or falls below
the PPS threshold.
Description
Mode Description
Global Disables each SNMP trap.
CLI
141