Configuring Lacp - SMC Networks 7824M/VSW - annexe 1 Manual

Management Guide
TigerAccess™ EE
i
8.2.2.1
SMC7824M/VSW
LACP can generate up to 5 aggregators whose number value could be 0 to 4. The group
ID of trunk port and the aggregator number of LACP cannot be configured with the same
value.
The following explains how to configure LACP.

Configuring LACP

•
Operation Mode
•
Priority of Switch
•
Manual Aggregation
•
• BPDU Transmission Rate
Administrational Key
•
Port Priority
•
Displaying LACP Configuration
•
Configuring LACP
Step 1
Activate LACP function, using the following command.
Command
lacp aggregator AGGREGA-
TIONS
Step 2
Configure the physical port that is a member of aggregated port. To configure the member
port, use the following command.
Command
lacp port PORTS
To disable LACP and delete the configuration of LACP, use the following command.
Command
no lacp aggregator AGGREGA-
TIONS
no lacp port PORTS
Mode
Enables LACP of designated Aggregator-number:
Bridge AGGREGATIONS: select aggregator ID that should be
enabled for LACP (valid value from 0 to 4).
Mode
Configures physical port that is member port of aggre-
Bridge gator; select the port number(s) that should be enabled
for LACP.
Mode
Disables LACP for designated Aggregator-number,
select the aggregator ID that should be disabled for
LACP.
Bridge
Deletes member port of Aggregator, select the port
number(s) that should be disabled for LACP.
Description
Description
Description
CLI
253