SMC Networks 7824M/VSW - annexe 1 Manual page 174

Management Guide
TigerAccess™ EE
!
!
SMC7824M/VSW
When specifying a source and destination IP address as a packet-classifying pattern, the
destination IP address must be after the source IP address.
To specify a packet-classifying pattern with various parameters (DSCP, CoS, ToS, IP
precedence, packet length, Ethernet type, IP header), use the following command.
Command
dscp {<0-63> | any}
cos {<0-7> | any}
tos {<0-255> | any}
ip-precedence {<0-7> | any}
length {<21-65535> | any}
ethtype {TYPE-NUM | arp | any}
ip header-error
ip header-length <1-15>
ip header-error command can be used only when specifying a source and destination IP
address as a packet-classifying pattern.
Mode
Classifies a DSCP value.
0-63: DSCP value
any: any DSCP (ignore)
Classifies an 802.1p priority.
0-7: 802.1p priority value
any: any 802.1p priority value (ignore)
Classifies all ToS field.
0-255: ToS value
any: any ToS value (ignore)
Classifies IP precedence.
0-7: IP precedence value
any: any IP precedence value (ignore)
Flow
Classifies a packet length.
(This can be used only in the extension mode!)
21-65535: IP packet length
any: any IP packet length (ignore)
Classifies the Ethernet type.
TYPE-NUM: Ethernet type field (hex, e.g. 0800 for
IPv4)
arp: address resolution protocol
any: any Ethertype (ignore)
Classifies the IP header-error.
Classifies the IP header-length.
1-15: IP header-length value
Description
CLI
173