Configuring The Ams200 Subsystem - Acer HDS AMS200 Reference Manual

6.3

Configuring the AMS200 Subsystem

The following steps must be performed to configure the disk array:
1. Verify that the subsystem is connected to the LAN.
2. Install Storage Navigator-Modular on the system that will be used as the management
PC/Server.
See the Acer | HDS Adaptable Modular Storage and Workgroup Modular Storage Storage
Navigator Modular Graphical User Interface (GUI) User's Guide to use a GUI interface.
See the Acer | HDS Adaptable Modular Storage and Workgroup Modular Storage Storage
Navigator Modular Command Line Interface (CLI) to use the CLI version.
Refer to the section titled, Installing Storage Navigator-Modular for instructions on how
to install the program.
3. Register the disk array for control by Storage Navigator-Modular.
4. Set the system parameters using the appropriate installation guide for the desired host
platform(s).
5. Reboot the disk array to complete the configuration.
Note: If the setting operation is performed for the array unit connected to the NAS unit, the
cluster between the NAS Units stops. When the setting operation for the array subsystem is
unavoidably performed, execute it after stopping the cluster between the NAS Units and
stopping the NAS OS of both NAS Units. Start the cluster between the NAS Units again after
completing the setting operation for the array subsystem.
118 Chapter 6 Configuring the AMS200 Subsystem