7.11 Setting Host Connection Parameters; 7.11.1 Simple Setting - Acer HDS AMS200 Reference Manual

7.11 Setting Host Connection Parameters

There are two methods for setting options:
Simple Setting for Connecting to the Host Computer
When using the simple setting, select the environmental elements of the host computer
to be connected. When the selection is made, the host group options (host connection
mode 1 and 2) necessary for the host computer to be connected are set automatically.
Detailed Setting for Each Host Connection
When using the detailed setting, directly set the necessary host group options (host
connection mode 1 and 2) in the same way as the conventional one.
The host group Information does not need to be set for the NAS system.

7.11.1 Simple Setting

Set the host group options (host connection mode 1 and 2) that are necessary for the host
computer to be connected. To do this, select the environmental elements of the host, such
as platform, alternative path, fail-over, and additional parameter. Some host environments
require a detailed setting as well as the simple setting. For details, refer to Table B.2.
1. In the Unit window, click the Logical Status tab.
2. Double-click Host Groups or Target (when iSCSI interface board is added). Double-click
the Port that you want to set for the connection mode with the host to display
000:G000.
3. Display the Options and Logical Unit by double-clicking 000:G000, and select the
Options:
178 Chapter 7 Configuring Storage on the Thunder 9530™ V Series Subsystem