Acer HDS AMS200 Reference Manual page 268

Table 8.6 Progress Messages (continued)
Message Code
I1B100
I1C0xy
I1C1xy
I1E000
I1E100
I61D00
IA100x
IA110x
IA120x
IA130x
IA140x
IA150x
IA1P0x
IA1Q0x
IA1T0x
IA1U0x
IA1V0x
IA2R00
248 Chapter 8 Troubleshooting
Message Text
Forced parity correction completed
Loop diagnostic start
(Path-x, Loop-y)
Loop diagnostic end
(Path-x, Loop-y)
Online verify completed
[odd unit]`
Online verify completed
[even unit]
Shutdown warning
NNC power on
(NNC-x)
NNC boot started
(NNC-x)
NNC is ready
(NNC-x)
NNC shutdown started
(NNC-x)
NNC shutdown completed
(NNC-x)
NNC power off
(NNC-x)
NNC NAS OS installation completed
(CTL-x, NNC-y)
NNC NAS OS installation started
(CTL-x, NNC-y)
NNC NAS dump process started
(NNC-x)
NNC recovered from partial alarm
(NNC-x)
NNC recovered (NNC-x)
NNC PCI Express link recovered [x]
(NNC-y)
Recovery Measures
Forced parity recovery processing was finished.
Loop diagnosis was started.
(x: Path# (0 or 1), y: Loop# (0 or 1))
Loop diagnosis was finished.
(x: Path# (0 or 1), y: Loop# (0 or 1))
Check of the frames with even numbers was completed in the
online verification.
Check of the frames with odd numbers was completed in the
online verification.
Turn off power supply by main switch.
NCC power supply was turned on.
x: NNC # （ 0-3 ）
NNC boot was started.
x: NNC # （ 0-3 ）
NNC is ready.
x ： NNC # （ 0-3 ）
NNC shutdown was started.
x ： NNC # （ 0-3 ）
NNC shutdown was completed.
x ： NNC # （ 0-3 ）
NNC power supply was turned off.
x ： NNC # （ 0-3 ）
NAS OS installation on the NNC. was completed
x ： Controller # （ 0-1 ）
y ： NNC # （ 0-3 ）
NAS OS installation on the NNC was started.
x ： Controller # （ 0-1 ）
y ： NNC # （ 0-3 ）
NNC Dump collection was started.
x ： NNC # （ 0-3 ）
NNC was recovered from a partial error.
x ： NNC # （ 0-3 ）
NNC was recovered from an error.
x ： NNC # （ 0-3 ）
The link of the NNC PCI Express was recovered.
x ： Failed part code
y ： NNC # （ 0-3 ）