Table of Contents
Advertisement
2. A created logical unit number displays for the Logical Unit No. and the RAID group
number in which logical units are defined for the RAID Group. Additionally, a logical unit
capacity that can be created displays.
Note: To specify a size explicitly in figures, select a unit to specify the size from among
the GB, MB, and Block. Specify the size to be allocated in decimal number.
The subsystem can be divided into a maximum of 2,048 logical units.
Note: The logical unit number may be set optionally when the logical unit is created.
However, the logical unit number 0 is assigned to the logical unit created first.
3. After the setting is complete, click OK.
4. The set logical unit information is updated and the window displays.
Figure 7.7
7.4.6
Deleting the Last Logical Unit
To delete the last logical unit, follow these steps:
1. Click the Logical Status tab on the Unit window.
2. From the Unit window, select the icon of logical unit to be deleted.
3. On the Settings menu, select Logical Unit and click Delete.
Note：The logical units being used in the NAS system may be unable to be deleted.
4. A confirmation message displays indicating whether selected logical units should be
deleted or not. Depending on whether the logical units to be deleted are formatted or
not, the message description is different. Click OK.
The logical unit information in which the logical unit has been deleted is updated and
the window displays.
144
Chapter 7 Configuring Storage on the Thunder 9530™ V Series Subsystem
Setting the Logical Unit Dialog Box
Advertisement
Table of Contents
Troubleshooting
