Web Operational Procedures; Connecting To The Network Using A Lan Interface; Figure 8.1 Lan Connector Location - Acer HDS AMS200 Reference Manual

Acer hds ams200 server: reference guide
Table of Contents

Advertisement

8.3

Web Operational Procedures

This section contains the following information:

Connecting to the network using a LAN interface.

Screen outlines.
Main screen in normal mode.
Status display of replaceable components.
Information message.
Setting the buzzer sound volume.
8.3.1
Connecting to the Network using a LAN Interface
To use a LAN interface, follow these steps:
The connector for 10Base-T/100Base-TX is equipped with the controller. 10Base-
T/100Base-TX is selected automatically.
Connect the LAN cable with the LAN connector shown in Figure 8.1.
The following figure is an example, illustrating when the FC interface board is not added to
the control unit.
Figure 8.1
LAN Connector Location
Change the IP Address of the controller set up to the Address of the Web browser, to enter
Normal Mode. Set the IP Address of the controller connected with the network as a dual
system configuration. The status of the devices (both controllers) can be monitored from
one controller.
218
Chapter 8 Troubleshooting
LAN connector
LASER KLASSE 1
CLASS 1
LASER PRODUCT

Advertisement

Table of Contents
loading

Table of Contents