Acer HDS AMS200 Reference Manual page 264

The contents of each message are shown in the following examples:
CUDG (Self-test at power-on) Detection Message.
The CUDG detection message is displayed in the Controller 0 or Controller 1 box as shown in
the following example:
Example:
Controller x
MM/DD/YYYY HH:MM:SS Cx C0
MM/DD/YYYY HH:MM:SS Cx B0
MM/DD/YYYY HH:MM:SS Cx A0
MM/DD/YYYY HH:MM:SS Cx 90
MM/DD/YYYY HH:MM:SS Cx 80
MM/DD/YYYY HH:MM:SS Cx 70
MM/DD/YYYY HH:MM:SS Cx 60
MM/DD/YYYY HH:MM:SS Cx
MM/DD/YYYY HH:MM:SS Cx CTLx
MM/DD/YYYY: Date of occurrence
HH:MM:SS: Time of occurrence
Cx: # of Controller in which failure is detected
Y Y M M D D : Date of occurrence
H H M M S S : Time of occurrence
⎯⎯⎯⎯
CTLx: CUDG executing controller #
Flash/RAM Micro Detection Message.
The Flash/RAM micro detection message is displayed in the Controller 0/1 Common,
Controller 0, or Controller 1 box, as shown in the following example. The latest one is
shown on the top line.
Note: The date and time the RTC is set in the detection controller is displayed in this
message. If the RTC is different from one control to another, the displayed time of
occurrence may differ within messages (the message on the upper line is issued prior to the
message on the lower line).
244 Chapter 8 Troubleshooting
: PCI Config information
: Detailed information
: Message code
: Message text (Any number of letters)
: Reservation area
Y Y M M D D ─── H H M M S S ⎯ ⎯⎯⎯⎯⎯⎯⎯⎯