Acer HDS AMS200 Reference Manual page 211

8. A confirmation message box displays. Click OK.
9. When all the Current values are the same as the set value on the Configuration Settings
screen, and the Normal is displayed on the Result, the setting is completed.
If the Setting is displayed in the Result, click the Refresh on the Configuration Settings
screen after a brief interval.
When the setting does not terminate correctly, the following messages will be displayed in
the Result.
No. Display in the Result
1 ---
2 Setting
3 Alert (Time-out of Disconnection)
4 Alert (Internal Error)
Failure and Measure
An unexpected setting result value was received from
through Storage Navigator Modular.
Press the Refresh button again to refresh the display.
When the display is not changed how many times the
above operation repeated, make the setting again.
If the same information is displayed in spite of the above
operation, contact the maintenance personnel.
The setting is being changed.
Wait for about 5 minutes, and then press the Refresh
button again to refresh the display.
If the same information is displayed no matter how many
times the update is repeated, contact the maintenance
personnel.
The setting could not be changed because the effective
connection was set for the maintenance port.
When the failure monitor service is used with the ASSIST
through a maintenance port connection, contact the
maintenance personnel.
Except for the above case, make the setting again.
If the same information is displayed in spite of the above
operation, contact the maintenance personnel.
The setting could not be changed because the
processing could not continue inside the subsystem.
When a failure occurs in the subsystem, contact the
maintenance personnel.
When no failure occurs in the subsystem, make the
setting again.
If the same information is displayed in spite of the above
operation, contact the maintenance personnel.
Acer | HDS AMS200 User and Reference Guide 191