Tacacs+ And Radius Server Configuration; Tacacs+ Server Installation And Configuration - Safran WR-ZEN Series User Manual

The magnitude that was measured in the unit's testing setup is additive phase
noise. We have not measured the noise of the external reference, but only the
noise that is linearly added by the WR-ZEN as the 10 MHz time signal is con-
sumed and regenerated. For more information on your unit's documented jitter
performance, see the product data sheet.
9.9

TACACS+ and RADIUS server configuration

9.9.1

TACACS+ server installation and configuration

In order to install TACACS+ on a server with Ubuntu 18.04, it is possible to use
APT to install version 4.0.4 of the package tacacs+ by using the following com-
mand:
apt-get install tacacs+
After this, it can be verified if the service is running by using the command:
service tacacs_plus status
The first step to configure the server will be opening the port 49 with TCP:
#ufw allow 49/tcp
Rules updated
Rules updated (v6)
The users are configured in the file /etc/tacacs+/tac_plus.conf. To do this, it
is possible to modify the key by replacing it by the one we want to define:
key = sevensecret
The following simple structure can be used to define a user:
user = test-tacacs {
pap = cleartext password
}
It is possible to encrypt the password with the "tac_pwd" terminal command and
enter the password to the settings as follows:
pap = des yD0g3Qn/0ZDsg
Being yD0g3Qn/0ZDsg the encrypted password.
WR-ZEN Series User Manual
APPENDIX
203