Figure 3-2:
3.2.5.2
Logging in from SSH
It is also possible to connect to the device via SSH with Putty
The process to connect to the UART using Windows (XP, Vista, 7, 8, 10) is
explained below:
Compatibility with wrz_config
In order to make Putty compatible with the wrz_config color scheme and avoid
strangecharacters, it is recommended to try the following configuration:
3.2.6
Logging in from web
Once the device is set with an IP address, it can be accessed by typing
http://<device_ip> in the browser address bar. By default, https is disabled but if
it has been enabled, the address bar should be replaced by https://<device_ip>.
CHAPTER
•
3
WR-ZEN Series User Manual Rev. v5.1
Putty configuration for serial port connection.
1. Download and install the Putty Tool.
2. Verify that the Connection type corresponds to SSH .
3. Finally, write root@<IP> under the Host Name (or IP address) field, and
click on Open.
1. Change remote character set to ISO-8859-1.
2. Uncheck "Override with UTF-8 if locale says so".
3. Select "Use Unicode line drawing code points" (this is the default).
3.2 Connecting to the Device
31