Logging From Ssh; Table 3-2: Uart Settings - Safran WR-ZEN Series User Manual

Multiple software can be used to read from the UART in the computer depending
on the operating system used for that purpose (e.g. Minicom, Picocom or Putty).
Learn more in the below sections.
The following table summarizes the settings required to connect to the serial port
(UART) of the device:
Table 3-2:
Baud Rate
Data
Parity
Stop bits
Flow Control
3.2.3

Logging from SSH

There are three main ways to connect to the WR-ZEN device from SSH:
CHAPTER •
3 WR-ZEN Series User Manual Rev. v5.1
UART Settings
Setting
Caution:
Remote authentication servers (TACACS+/Radius): If there is any
remote authentication server configured and it is responding, the
local credentials of the user root will not be used. Only if the remote
server is not working or is unreachable, will the local credentials be
available again. This can render the device accessible only by UART.
1. To use the default static IP on eth1:
Connect the RJ-45 Ethernet cable to the eth1 interface.
Connect the host interface to the same LAN and configure its IP
address to be within the same netmask.
Access the device by typing in the host terminal:
ssh root@192.168.77.100
2. To use a DHCP server on eth0:
Connect the RJ-45 Ethernet cable to the eth0 interface and to a LAN
network with a DHCP server.
Connect the host interface (your PC) to the same LAN, to obtain
another IP address.
3.2 Connecting to the Device
Value
115200 bps
8 bits
None
1 bit
none
27