Info/Overview - Safran WR-ZEN Series User Manual

19.xx13.x
19.xx13.9
19.xx13.10
19.xx13.14
19.xx13.11
19.xx13.20
19.xx13.21
19.xx13.22
19.xx13.23
19.xx13.24
5.4.3

Info/Overview

Each PTP port runs its own PTP instance independently on a specific process.
The information about the instance can be obtained from command line, using
for example the following command for the first port (wr0):
gpa_ctrl wptpd net/wr0/1/info/
Or through the web interface as shown below, where each port is displayed by a
row (see the table
more details on the provided parameters). The PTP Overview page is located at
Overview > Timing > IEEE-1588-2008 (PTPV2).
CHAPTER •
5 WR-ZEN Series User Manual Rev. v5.1
OID Name
net/<iface>/1/cfg
Transport
Protocol
Delay Mech-
anism
Domain
Transport
Mode
Announce
Rate
Sync Rate
Delay req
Rate
Peer Delay
req Rate
PTP Times-
cale
"PTP information for a port interface" on the next page
Range
Default
Value
Min Max
UDP/IPv4
E2E
0 0 255
Multicast
1 1/128 16
8 1/128 128
8 1/128 128
8 1/128 128
PTP - -
5.4 IEEE 1588-2008 (PTPv2)
Note
IP address must be set before set-
ting transport protocol to
UDP/IPv4. Layer 2 is also sup-
ported.
E2E and P2P are supported.
Multicast, Unicast and Hybrid
modes are allowed.
We only support PTP as "PTP
Timescale"
for
95