Tacacs+ Client Configuration - Safran WR-ZEN Series User Manual

6.3 TACACS+
Figure 6-2: TACACS setup for verifying the installation.
6.3.2

TACACS+ Client configuration

Once the server is configured, it is necessary to configure the client. In this sec-
tion, the client will be configured on the WR-ZEN device. For that purpose, gpa_
ctrl is used to configure IP and secret. These parameters can be found in the
security module:
root@zen- 305:~# gpa_ ctrl - s security auth/tacacs/server1_ ip
172.17.5.39
root@zen- 305:~# gpa_ ctrl - s security auth/tacacs/server1_ secret
sevensecret
And reboot to apply the changes.
Then the client can be accessed by using the configured user and password. In
order to get debug messages from TACACS+, the service can be launched with
the command tac_plus-g, always indicating the configuration file. For example, in
the screenshots of figure a successful access with the TACACS+ password the
first time, failed the second time and succeeded the third. Below you can see the
verbose tac_plus output.
CHAPTER •
115
6 WR-ZEN Series User Manual Rev. v5.1