Main Screen - Safran WR-ZEN Series User Manual

This is the screen you usually see when not interacting with the device. This is a
screen saver screen, showing the IPs of each interface to connect to the device.
When you press INFO/CTRL button the main menu will appear.
You can configure the screen saver options with these parameters:
You can change these values through gpa_ctrl or snmp.
7.5.2

Main Screen

When you press INFO/CTRL button, or if the screen saver is not active, you can
see the main screen.
The main screen has the next structure:
This screen shows the general status of your device. Status can be:
If you press INFO/CTRL button, the main menu will show.
CHAPTER •
7 WR-ZEN Series User Manual Rev. v5.1
cfg/screen_saver:
1: screen saver configured.
0: no showing screen saver (the screen turns off when screen_saver_
dealy is reached).
cfg/screen_saver_delay: time without pressing INFO/CTRL button before
active screen_saver.
Note: The screen saver option was removed in firmware version 5.1.
Ok: All is ok.
Alert: There is at least a parameter with warning values.
Critical: There is a problem with at least one parameter value or module.
7.5 LCD screen menu
151