Sfp Ports; Table 2-6: Ports Led Behavior - Safran WR-ZEN Series User Manual

1
0
1
0
1
0
1
0
1
0
1
0
2.3.2

SFP Ports

The network ports of the device are arranged in a dual stack SFP cage. The fol-
lowing table represents only the two first ports but can be extrapolated to the
other ones. The LEDs of these SFP ports are slightly different to standard usage
as it does not differentiate TX/RX but utilizes the arrows to indicate the upper-
/lower port and their corresponding states:
Table 2-6:
CHAPTER •
2 WR-ZEN Series User Manual Rev. v5.1
Visual Behavior
●●●
Steady Red &
●●●
Green
●●●
2x Blinking
●●●
Green
●●●
Idle
●●●
●●● 3x Blinking
●●●
Green
●●●
Steady Red &
●●●
Green
●●●
Nx Blinking
●●●
Red & Green
Ports LED behavior
Visual
Device is booting in reset factory mode
Booting in normal mode
Device is loading kernel and transitioning between
modes
FPGA initialization OK
The hald daemon has been loaded and it is waiting till
all daemons are properly loaded
Device is loading in failsafe mode and for each module
skipped during initialization the device blinks in orange
ID Behavior
0 wr0
B Link down
▲
▲
Link up
▲
D Activity
1 wr1
▼
A Activity
C Link down
▼
▼
Link up
2.3 Monitoring LEDs
Description
Description
wr0 corresponds to upper
SFP in the stack
When link is down led B is dis-
abled
When link is up the led B stays
in green
Blinks in orange each time a
packet is received on this port
wr1 corresponds to lower
SFP in the stack
Blinks in orange each time a
packet is received on this port
When link is down led C is dis-
abled
When link is up the led C stays
in green
17