Wr Slave @ Wr0 > Wr1 (Bc); Ptp Slave @ Wr0 > Wr1 (Bc); Wr Slave @ Wr0 / Ptp Fan-Out - Safran WR-ZEN Series User Manual

5.2.1.6 WR Slave @ wr0 > wr1 (BC)
Web GUI selection: BC: wr0->wr1|WR
This preset provides multi-source redundancy by allowing to configure the two
first optical ports as possible timing sources. This means that in case of failure of
the first port (i.e., wr0), the device will automatically switch to wr1 as it is con-
figured as secondary source.
5.2.1.7 PTP Slave @ wr0 > wr1 (BC)
Web GUI selection: BC: wr0->wr1|PTP (PTP)
This preset provides multi-source redundancy by configuring the two first optical
ports as possible timing sources. In case of failure of the first port (i.e., wro), the
device will automatically switch to wr1, as it is configured as a secondary source.
5.2.1.8

WR Slave @ wr0 / PTP Fan-Out

Web GUI selection: BC: wr0|PTP
CHAPTER •
5 WR-ZEN Series User Manual Rev. v5.1
Note: Inform GNSS status via PPS: This preset enforces a continuous
detection of the PPS input. This means that if the GNSS receiver is
configured to disable its PPS when it unlocks (e.g., signal lost), the
Grand-Master will then automatically degrade itself as a Free-Run-
ning Grand-Master (see VSC-10102 in
Code)" on page 189).
The primary timing source is provided using WR through interface wr0. It
can failover to a secondary timing source provided using WR through inter-
face wr1.
All ports except for wr0 and wr1 are configured as WR masters.
The primary timing source is provided using PTP though interface wr0. It
can failover to a provided secondary timing source using PTP through inter-
face wr1.
All ports except wr0 and wr1 are configured as PTP slaves.
The primary timing source is provided using WR protocol through interface
wr0.
All ports except wr0 and wr1 are configured as PTP slaves.
5.2 General Timing Management
"Grand Master (GM VCS
75