Table of Contents
Advertisement
Program Status: Indicates the current Program Step:
Manual Mode:
Indicates Manual Mode has been selected. In Manual Mode, the Raise
and Lower buttons operate on the Output Power. In Automatic Mode (this icon is off), the
Raise and Lower buttons operate on the Set Point.
Output Indicators: Illuminate when the appropriate output is activated. Output 1 is the
Output Power sent to the Hydraulic Power Unit. The other outputs are unused.
F1: Toggles between Automatic and Manual mode. When in Manual Mode the "hand" icon
is illuminated.
F2: Program Run / Reset. Press once to Start the program. Press again to Reset the program.
Page: Used to page through the various menus in the controller.
Scroll: Used to scroll through the parameter settings within a menu page.
Note: Press Page + Scroll to return to the "Home" Display. When at the Home Display,
Page + Scroll will acknowledge any alarm.
Lower / Raise: Used to change the value of a parameter. Press and hold the button for rapid
changes
.
Configuring the controller to perform a sample temperature program involves
defining a series of ramp and dwell segments.
Once the program exists, the program is executed by pressing the F1 button to
select Automatic Mode (the "hand" icon will turn off) and then the F2 button to
start the program (the Program Status indicator will turn on).
To terminate the program, the F2 button is pressed to reset the program (the
Program Status indicator will turn off). Press the F1 button to place the controller
in manual mode (the "hand" icon will turn on).
SECTION 3 – OPERATING INSTRUCTIONS
Indicates Ramp / Step Up
Indicates Dwell (Flashing indicates
Dwell End)
Indicates Ramp / Step Down.
3-3
Advertisement
Table of Contents
