Ametek Chandler Engineering 5265MGSA Operation Manual page 14

SECTION 2 – SOFTWARE CONFIGURATION
2-2
4. Configure the instrument as shown below.
The "Temperature" Input Signal is not shown above:
• Type: Input Signal
• I/O Connection: TCP201
• Address: 2:1f
NOTES:
• 5270 will complain that the "Motor Speed" and "Motor Speed – Conditioning"
are using the same address. Click Yes when presented with the following dialog.
• The "Motor Speed", "Motor Speed – Conditioning" and "Motor Encoder" Input
Signals along with the "Motor Speed" Analog Output use the "l" (lower case L)
register type.
• The "Motor" Digital output is not used for this version of the 5265MG.
• The "Motor Encoder" and "Motor Temperature" Input Signals are not required
for normal operation. Chandler Engineering recommends that these signals be
configured but disabled.
• These addresses are listed in the 5270 Help file (Help > View Help; click the
"Instrument Addresses" link from the "Communication Details" page.
Figure 2 – Ethernet Instrument Configuration