Table of Contents
Advertisement
SECTION 3 – OPERATING INSTRUCTIONS
3-10
Load Cell Plug Installation / Removal
Cable Connections
There are 3 cables from the 5265MG Motor and Vessel Assembly:
1. 5265MX-0075 Load Transducer Assembly: connects to the "LOAD SENSOR" connector
on the Rear Panel of the Instrument.
2. X265-0107 Motor Power Cable: connects from the POWER connector on the motor to
the MOTOR POWER connector on the Rear Panel of the Instrument (see below).
DO NOT connect or disconnect this cable when the Instrument is ON. Damage to the
motor may occur.
3. C19216 Motor Ethernet Cable: connects from the "COM1 (IN)" connector on the motor
to the MOTOR COMM connector on the Rear Panel of the Instrument (see below).
NOTE: The COM2 and I/O connectors are not used and should be capped.
Figure 12 – Load Cell Plug Installation / Removal
Figure 13 – Motor Connectors
Advertisement
Table of Contents
