Table of Contents
Advertisement
Top Plug Disassembly / Assembly
1. Pull the paddle shaft assembly from the plug. The bottom baffle is equipped with an
o-ring used to retain the baffle within the plug.
2. Verify that the thermocouple port and fill ports are not filled with the cement and the
thermocouple slides freely into the port. Applying thin layer to grease to the
thermocouple prevents cement from bonding to the internal port surface.
3. Remove and clean the paddle, removing all cement from previous testing.
4. Remove and clean the baffles on the paddle shaft, removing all cement from previous
testing.
5. Slide the inner magnet assembly, spacer, bearings, baffles, paddle shaft and paddle
into the plug.
SECTION 3 – OPERATING INSTRUCTIONS
Figure 9 – Paddle Shaft Assembly
3-7
Advertisement
Table of Contents
