Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Ametek JofraCloud 3G Gateway
Summary of Contents for Ametek JofraCloud 3G Gateway
- Page 1 Reference Manual Remote Calibrator Operation for RTC and PTC Series...
- Page 2 Reference Manual Remote Calibrator Operation For RTC and PTC Series Copyright 2017 AMETEK Denmark A/S...
- Page 3 The structure of the manual This reference manual is aimed at users who are familiar with AMETEK Remote Calibrator Operation System - JofraCloud, as well as those who are not. The manual is divided into 10 chapters, which describe how to set up, operate, service and maintain the unit. The technical specifications are described and accessories may be ordered from the list of accessories.
-
Page 4: Table Of Contents
List of contents 1.0 Introduction ............................. 4 Warranty ..............................5 Receiving the JofraCloud Unit ........................6 2.0 Safety instructions .......................... 7 3.0 Installing the JofraCloud unit ......................8 4.0 Operating the JofraCloud Unit ..................... 10 Concept of the Gateway ........................... -
Page 5: Introduction
Introduction Congratulations on your new AMETEK Remote Calibrator Operation - JofraCloud! With the AMETEK Remote Calibrator Operation System – JofraCloud Gateway, you have chosen an extremely effective unit, which we are sure will perform according to your expectations. This unit enables remote reading and set point adjustment at an unlimited distance. -
Page 6: Warranty
This unit is warranted against defects in workmanship, material and design for two (2) years from date of delivery to the extent that AMETEK will, at its sole option, repair or replace the unit or any part thereof which is defective, provided, however, that this warranty shall not apply to units subjected to tampering or, abuse, or exposed to highly corrosive conditions. -
Page 7: Receiving The Jofracloud Unit
Receiving the JofraCloud Unit When you receive the unit… 1) Unpack and check the unit and the accessories carefully. 2) Check the parts according to the list shown below. If any of the parts are missing or damaged, please contact the dealer who sold you the JofraCloud System. -
Page 8: Safety Instructions
Safety instructions Read this manual carefully before using the instrument! Please follow the instructions and procedures described in this manual. They are aimed at allowing you to make the best of your JofraCloud Gateway and avoid any personal injuries and/or damage to the unit. Disposal –... -
Page 9: Installing The Jofracloud Unit
Installing the JofraCloud unit The Gateway uses the 3G network, and needs coverage. In a building with poor 3G coverage, an external antenna may be needed. Note… The firmware in the RTC / PTC instrument must be 1.0.1564 or higher. 1. - Page 10 3. Connect the antenna to the SMA connector marked “CELL”. The antenna shall point upward. GNSS antenna connector Cellular antenna connector 4. Connect the Power supply 6-pin connector to the Gateway. Ethernet Power 129889 00 2017-11-03...
-
Page 11: Operating The Jofracloud Unit
Operating the JofraCloud Unit Warning Please inspect the Safety Instructions in section 2.0 before using the instrument. Caution… Please inspect the Safety Instructions in section 2.0 before using the instrument. Concept of the Gateway A 3G Gateway attached to the RTC / PTC Calibrator reads data from the calibrator every 2 seconds ... -
Page 12: Led Functionality
4.2.1 LED functionality User LED Power LED User LED Not connected to the calibrator Green : Connected to the calibrator Power LED Powered but not connected to the network Amber : Powered and connected to the network 4.2.2 Network setting 1. -
Page 13: Registration
Registration 1. Go to jofracloud.com and select “Sign Up” 2. Fill in the form with company details and contact information. This will be used for future login and for addition of more users. 3. Press “Sign Up”. The account just created will be with the role: Administrator 4.3.1 Forgotten password 1. -
Page 14: Customer Administration
Customer Administration 1. Select “Customer” from the Menu on the left side of the screen, and press “Edit” Logged in User name Customer name Customer address Here you can change the information shown in the top right corner of the screen and on reports. -
Page 15: Roles
3. By clicking on the link sent by E-mail, you are directed to the page shown below. Enter a password with minimum 6 characters. There are no requirements for capital letters, numbers or special characters. 4.5.2 Roles Currently there exist two roles: Administrator: ... -
Page 16: Adding A New Calibrator
4.6.1 Adding a new calibrator Before adding a new calibrator, the device must be connected to the Gateway. Both the Gateway and calibrator must be powered up. Lights on the Gateway shows good status (see chapter 4.2.1). Note… Only Administrators can add new calibrating devices. 1. -
Page 17: Enter New Setpoint
The temperature is a random number between 10°C and 40°C, and uses the decimals set on the instrument. °C You have 60 seconds to set the setpoint. If you miss it; repeat the claim procedure. 10. After ownership is confirmed, press “View” The actual data on the instrument will be shown. -
Page 18: Sign Out
Sign out 1. To sign out of the JofraCloud system select “Sign Out” from the “Other” menu on the left side of the screen. You are now in the Sign In mode and it is safe to close the jofracloud.com. 129889 00 2017-11-03... -
Page 19: Subscriber Identity Module (Sim)
To remove a SIM card, press the SIM card in, and release it. Gently grip the SIM card and pull it out. 4. Re-mount the cover. 5. Contact AMETEK Denmark A/S for configuration of the Gateway to the new SIM card. 129889 00... -
Page 20: Security
Security To ensure data security we have implemented the following: The communication between the user’s browser and the portal are encrypted using the standard https (SSL/TLS Passwords are stored encrypted in the database. 129889 00 2017-11-03... -
Page 21: Maintenance
For maintenance procedures not described in this manual, or if the JofraCloud Gateway needs repair, please contact AMETEK Denmark Service Department as described below in section 7.1 “Returning the JofraCloud Gateway to service”. Returning the JofraCloud Gateway to service If the JofraCloud Gateway continuously malfunctions, verify that the system is being operated as described in this manual and return it to the manufacturer for repair/service. - Page 22 _____________________________________________________________________________________________________ Safety precautions: if the product has been exposed to any hazardous substances, it must be thoroughly decontaminated before it is returned to AMETEK Denmark A/S. Details of the hazardous substances and any precautions to be taken must be enclosed.
-
Page 23: Storing
Storing It is not necessary to store away the JofraCloud Gateway after use. The unit can be part of a continuous set-up, as long as it is kept in a dry, clean place. Cleaning Caution… Before cleaning the JofraCloud Gateway, you must switch it off. Periodically wipe the case of the JofraCloud Gateway with a damp soft cloth. -
Page 24: Errors
Power cycle both the calibrator and the Gateway Refresh the browser window Both LEDs on the Gateway shows Contact AMETEK Denmark A/S or your local dealer good status, but calibrator is offline 129889 00 2017-11-03... -
Page 25: Technical Specifications
Technical specifications FX30 Gateway Description Value Frequency bands : B1 / B2 / B5 / B6 / B8 / B19 EU Directive 2014/53/EU Radio Equipment Directive: Approvals : Article 3.1 (a) Protection of health and safety EN 60950-1:2006/A1:2010/A11:2009/A12:2011/A2:2013; EN 62311:2008 Article 3.1 (b) Electromagnetic compatibility EN 301 489-1 V1.9.2;... - Page 26 Description Value (continued) Humidity : 10% ~ 90% Operational temperature : 0°C ~ 40°C (operates normally) Storage Temperature : -30°C ~ 70°C International Efficiency Level 115 VAC, 60 Hz : 230 VAC, 50 Hz : 129889 00 2017-11-03...
-
Page 27: 10.0 List Of Accessories
10.0 List of accessories All parts listed in the list of accessories is available from the factory through our dealers. Please contact your dealer for assistance if you require parts, which do not appear in the list. List of accessories Accessories Part no. - Page 28 Tel +86 10 8526 2111 Tel +49 (0)2159 9136 510 India jofra-china.sales@ametek.com.cn info.mct-de@ametek.de Tel +91 22 2836 4750 jofra@ametek.com Denmark Tel +45 4816 8000 jofra@ametek.com Information in this document is subject to change without notice. ©2017 by AMETEK, Inc., www.ametek.com. All rights reserved.