Using The Integral Modem In Standalone Csus; Entering Numbers In The Phone Directories - Paradyne 3150 Operator's Manual

Using the Integral Modem in
Standalone CSUs
The standalone CSU's integral modem enables your
CSU to communicate with remote devices to display
alarm messages or to function as the user interface. The
carrier-mounted CSU does not have an integral
modem.
The Call command, available from the Control branch
of the menu tree, provides the following functions to
initiate and terminate modem connections:
Pass – Initiates a call through the integral modem
to access a far-end CSU's front panel from your
CSU's front panel (or PC attached to the COM
port).
Dial – Initiates a call through the integral modem to
a printer, ASCII terminal, or PC. Sets up a
semipermanent connection to route alarm messages
to the specified destination.
Disconnect – Disconnects an active modem
connection.
Change Directory – Allows entry of phone
numbers into the internal phone directories.
For additional information, refer to the
Configuration Options section in Appendix C.

Entering Numbers in the Phone Directories

The CSU has five general directories (1 through 5) and
one alarm directory (A). Use the general directories to
store phone numbers for remote devices such as
standalone CSUs and ASCII printers. Use the alarm
directory to store the phone number of the primary ASCII
terminal or printer you use to display or print alarms. This
function is not available for carrier-mounted CSUs
because the integral modem is not available for
carrier-mounted CSUs.
3150-A2-GB21-80
To enter or change numbers in the phone directories,
1. From the top-level menu screen, press the
2. Select Ctrl.
3. From the Control screen, select Call.
4. From the Call Setup screen, select ChDir.
User Interface
5. Press F1 (Next) to display the next directory (2, in
February 1998
until the Ctrl selection appears on the screen.
Control:
Call ACO
F1 F2
Call Setup:
Dial Disc
F1 F2
The Directory 1 displays first, along with its
phone number if one has been entered.
this case). Press F2 (Previous) to display the
previous directory (A, in this case). Directories
appear in order, 1 through 5 and then A.
1: xxxxxxxxxxxxxxxxx
Next Prev
F1 F2
Operation
key
Rel
F3
ChDir
F3
Edit
F3
3-21