Paradyne 3150 Operator's Manual page 95

Com Link: PPP
Next PPP SLIP Prev
Com Port Link Layer Protocol. Specifies the link layer protocol for the communication port if the Com Use configuration
option is set to Mgmt or Daisy.
PPP – Specifies PPP as the link layer protocol for the IP management link on the communication port.
SLIP – Specifies SLIP as the link layer protocol for the IP management link on the communication port. The
communication port must be configured for asynchronous operation to support SLIP. This selection does not appear if the
Com Use configuration option is set to Daisy.
NOTE: This configuration option is not available on carrier-mounted CSUs if the communication port is disabled.
Modem IP Adr:
Next Edit Clear Prev
Modem Port IP Address. Specifies the IP address for the modem port if the Modem Use configuration option is set to
Mgmt.
Edit – Allows you to edit or display the IP address for the modem port.
Clear – Allows you to clear the IP address for the modem port. The IP address is set to 000.000.000.000.
NOTE: This configuration option is available on standalone CSUs only.
Mdm NetMask:
Next Edit Clear Prev
Subnet Mask for the Modem Port. Specifies the Subnet Mask for the modem port if the Modem Use configuration option
is set to Mgmt.
Edit – Allows you to edit and/or display the Subnet Mask for the modem port.
Clear – Allows you to clear the Subnet Mask for the modem port. The Subnet Mask is set to 000.000.000.000. If the
Subnet Mask is 000.000.000.000, the IP protocol creates a default Subnet Mask based on the class of the IP address
(Class A: 255.000.000.000, Class B: 255.255.000.000, or Class C: 255.255.255.000).
NOTE: This configuration option is available on standalone CSUs only.
Alt Mdm IP Adr:
Next Edit Clear Prev
Alternate Modem Port IP Address. Specifies the alternate IP address for the modem port if the Modem Use configuration
option is set to Mgmt. This IP address is needed if a call attempt does not complete on the primary alarm/trap phone
number (contained in the alarm directory) and the alternate dial out directory is used to try another phone number.
Edit – Allows you to edit or display the alternate IP address for the modem port.
Clear – Allows you to clear the alternate IP address for the modem port. The IP address is set to 000.000.000.000.
NOTE: This configuration option is available on standalone CSUs only.
3150-A2-GB21-80
Table C-6
(4 of 6)
General Management Configuration Options
February 1998
Configuration Options
C-21