Lamp Test; Aborting Test Patterns; Starting A Lamp Test - Paradyne 3150 Operator's Manual

Aborting Test Patterns

Use the Abort command to stop all test patterns or any
selected test pattern active on the CSU.
To abort test patterns,
1. From the top-level menu screen, select Test.
2. From the Test screen, select Ptrns.
Test:
Rlpbk Lpbk
F1
3. From the Patterns screen, select Abort.
Patterns:
Abort
F1
4. From the Patterns Abort screen, press the desired
Function key to abort either All active test
patterns, active Send test patterns, or the active
Monitor (Mon) test pattern.
Patterns: Abort
All
F1
The CSU terminates the selected test pattern and
displays the message Command Complete.
NOTE
If you mistakenly choose to abort a
test pattern that is not currently
running, a Command Complete
message still displays and the test
pattern currently active still runs. Use
the TStat branch to view the test
status to determine if the abort was
successful.
3150-A2-GB21-80
Ptrns
F3
F2
Send Mon
F2 F3
Send Mon
F2 F3
February 1998

Lamp Test

Use the Lamp Test commands to start and stop a test of
the CSU front panel LCD and LEDs.

Starting a Lamp Test

To start a Lamp test,
1. From the top-level menu screen, select Test.
2. From the Test screen, press the
Lamp selection appears on the screen.
3. From the Test screen, select Lamp.
Test:
Lpbk
F1
4. From the Lamp Test screen, select Start.

Lamp Test:

Abort
F1
Maintenance
key until the
Ptrns Lamp
F2 F3
Start
F3
F2
4-19