Paradyne 3150 Operator's Manual page 97

IPBusMast: Disab
Next Enab Disab Prev
Setting the IP Bus Master. Specifies whether or not a particular carrier-mounted unit is the IP Bus Master. There can only
be one IP Bus Master per 3000 Series Carrier. Typically, the carrier-mounted unit that has the SNMP/Telnet management
system connected to it is the IP Bus Master. This allows for faster access to the remaining carrier units. If an SNMP/Telnet
management system is connected to another carrier-mounted unit (i.e. not the IP Bus Master) and the SNMP/Telnet
management system tries to access another carrier-mounted unit, the data has to be routed to the IP Bus Master first.
Once the IP Bus Master receives the data, it is routed to the appropriate slot.
Enab – This unit is the IP Bus Master. Only one IP Bus Master is allowed per 3000 Series Carrier.
Disab – This unit is not the IP Bus Master.
NOTE: This configuration option is available on carrier-mounted CSUs only.
Def Netwk: None
Next None IPBus
Default Network Destination. Specifies the default network destination. This configuration option specifies where the
default network is connected. For example, if the default network is connected to the communication port, you select
Com. If the default network is connected to the far-end 31xx Series device over the FDL, you select FDL. The routing
protocol uses the default network destination to route data that does not have a specific route.
None – No default network destination. Data that cannot be routed is discarded.
IPBus – The default network destination is the IP Bus on the carrier backplane. This selection only appears for
carrier-mounted CSUs which are not configured as the IP Bus Master.
Com – The default network destination is the communication port. This selection only appears if the Com Use
configuration option is set to Mgmt.
Modem – The default network destination is the modem port. This selection only appears if the Modem Use configuration
option is set to Mgmt. This selection does not appear on carrier-mounted CSUs.
Aux – The default network destination is the auxiliary port. This selection only appears if the Aux Use configuration option
is set to Mgmt.
FDL – The default network destination is FDL. This selection only appears if the FDL management link is enabled.
NOTE: If the chosen default network link is disabled or down, data is discarded. Return to this menu and choose another
default network.
3150-A2-GB21-80
General Management Configuration Options
Com Modem Aux FDL
Table C-6
(6 of 6)
Prev
February 1998
Configuration Options
C-23