Setting The Ip Address - Paradyne 3150 Operator's Manual

ACCULINK 315x CSU
The example shown below assumes that the COM port
is being used as the link to the SNMP or Telnet system.
To select the COM port as the SNMP or Telnet link,
1. From the top-level menu screen, select Cnfig.
2. Select the configuration option set to be copied
into the Edit area by using the appropriate
Function key. Use the scroll keys, if necessary.
3. Select Edit.
4. Select User.
Edit:
NET
F1
5. Press F1 (Next) until the Com Use configuration
option appears.
6. Select Mgmt to configure the COM port as the
SNMP or Telnet link.
Com Use:
Next
F1
3-12
Gen User
F3
F2
Mgmt ASCII
F2 F3
February 1998

Setting the IP Address

The IP address is the address used by the SNMP or
Telnet system to access the CSU (see Appendix F,
Network Addressing Scenarios). For CSUs using PPP, the
IP address can be negotiated if the network device (e.g.,
router or SNMP manager) supports such negotiation. The
IP address is composed of four fields with three digits per
field (xxx.xxx.xxx.xxx).
The IP address is set for the MODEM port, the COM
port, or the AUX port (with LAN Adapter or daisy chain),
depending on which one has been chosen as the SNMP or
Telnet communication link. The example below assumes
that an IP address of 010.155.111.222 is being set for the
COM port. You can use the same principles to assign any
value (between 000 and 255 for each digit field) to other
ports.
To assign an IP address to the COM port,
1. From the top-level menu screen, select Cnfig.
2. Select the configuration option set to be copied
into the Edit area by using the appropriate
Function key. Use the scroll keys, if necessary.
3. Select Edit.
4. From the Edit screen, press the
Mgmt selection appears on the screen.
5. Select Mgmt.
Edit:
User
F1
6. From the Mgmt Config screen, select Gen.
Mgmt Config:
Gen
F1
IP
key until the
Alarm Mgmt
F2 F3
Trap
F2 F3
3150-A2-GB21-80