User Interface Access Security For Standalone Csus - Paradyne 3150 Operator's Manual

User Interface Access
Security for Standalone CSUs
NOTE
This page of the manual is self-
supporting and can be removed to
prevent unwanted knowledge of the
security access levels and their
selection.
The user interface access security option allows you to
limit access to the CSU to display-only and non-intrusive
functions. The user access security function is not
available for carrier-mounted CSUs.
Level 1 (Lvl1) access security allows access to all
functions available through the menu tree. This is the
default setting.
Level 2 (Lvl2) access security restricts access to only
those functions that cannot affect the operation of the
CSU in any way. At this level,
None of the functions in the Test or Ctrl branches
are available.
All functions on the Stat branch are available.
All functions on the Cnfg branch are available for
display, but they cannot be used to save to a
configuration area.
You can only reach the screen that controls security
access using the front panel.
3150-A2-GB21-80
Changing User Interface Access Security
To change user interface access security,
1. Press the
screen.
2. Press the
3. Press the
The Security screen appears.
4. Press F1 to select Lvl1, or press F2 to select Lvl2.
After you make a selection, the top-level screen
appears.
If you do not make a selection within 5 minutes,
the Automatic Device Health/Status screen
appears.
February 1998
key two times from the top-level
CSU ESF
Stat Test Cnfig
F1 F2 F3
key three times.
CSU ESF
Stat Test Cnfig
F3
F1 F2
key once.
CSU ESF
Stat Test Cnfig
F1 F2 F3
Security:
Lvl1 Lvl2
F1 F2 F3
Operation
3-29