Ds1/E1 Mib (Rfc) - Paradyne 3150 Operator's Manual

ACCULINK 315x CSU
DS1/E1 MIB (RFC 1406)
The "ds1" object defined by RFC 1406 is supported for
both the network and DTE interfaces. The DS1 Near End
Group and DS1 Fractional Group are supported for both
interfaces. The DS1 Far End Group is not supported.
Near End Group, DS1/E1 MIB
The DS1 Near End Group consists of the following
four tables:
DS1 Configuration
DS1 Current
DS1 Interval
DS1 Total
All four tables are fully supported for the network
interface. Since statistics are not kept for the DTE
interface, only the DS1 Configuration table is fully
supported. The "statistic" objects for the DTE interface
entry in the DS1 Current, DS1 Interval, and DS1 Total
tables are always zero (null). The following sections
provide clarification for objects contained in the Near End
Group when it is not clear how the object definition in the
DS1/E1 MIB is related to the CSU.
Near End Group – "dsx1TimeElapsed" Object
(dsx1ConfigEntry 3)
Applies to the network interface only. An error status is
returned if access is attempted for the DTE interface.
Near End Group – "dsx1ValidIntervals" Object
(dsx1ConfigEntry 4)
Applies to the network interface only. An error status is
returned if access is attempted for the DTE interface.
E-8
Near End Group – "dsx1LineType" Object
(dsx1ConfigEntry 5)
This object corresponds to the NET Framing/DTE
Framing configuration options for the T1 interfaces on the
CSU. Only the following values are supported by the
CSU.
dsx1ESF(2) – Indicates ESF framing.
dsx1D4(2) – Indicates D4 framing.
Near End Group – "dsx1LineCoding" Object
(dsx1ConfigEntry 6)
This object corresponds to the NET Coding/DTE
Coding configuration options for the T1 interfaces on the
CSU. Only the following values are supported by the
CSU.
dsx1B8ZS(2) – Indicates B8ZS line coding.
dsx1AMI(5) – Indicates AMI line coding.
Near End Group – "dsx1SendCode" Object
(dsx1ConfigEntry 7)
This object specifies the test patterns/codes being sent
over the network interface. These tests are not supported
on the DTE interface. Only the following values are
supported by the CSU.
dsx1SendNoCode(1) – Specifies that the interface
is sending normal or looped data. Setting the
interface to this value stops an active "send pattern"
test on the interface. This is the only value
supported by the DTE interface.
dsx1SendLineCode(2) – Specifies that the network
interface is sending a Remote Loopback (Rlpbk)
LLBUP code. The code is sent for 10 seconds.
dsx1SendResetCode(4) – Specifies that the network
interface is sending Remote Loopback (Rlpbk)
LLBDN code. The code is sent for 10 seconds.
dsx1SendQRS(5) – Specifies that the network
interface is sending a QRSS test pattern. The
pattern is sent until the test is halted (i.e., setting to
dsx1SendNoCode).
dsx1SendOtherTestPattern(8) – Specifies that the
network interface is sending a 1-in-8 test pattern.
The pattern is sent until the test is halted (i.e.,
setting to dsx1SendNoCode).
February 1998 3150-A2-GB21-80