Paradyne 3150 Operator's Manual page 85

Com Rate: 9.6
Next 1.2 2.4 4.8
Communication Port Rate. Configures the bit rate for the communication port.
1.2 – Sets the bit rate to 1200 bps (for asynchronous operation only).
2.4 – Sets the bit rate to 2400 bps.
4.8 – Sets the bit rate to 4800 bps.
9.6 – Sets the bit rate to 9600 bps.
14.4 – Sets the bit rate to 14,400 bps.
19.2 – Sets the bit rate to 19,200 bps.
38.4 – Sets the bit rate to 38,400 bps. This rate is not supported for carrier-mounted CSUs.
NOTE: This configuration option is not available if the communication port is configured for synchronous operation and
the clock source is external.
Char Length: 8
Next 7 8 Prev
Communication Port Character Length. Configures the character length (7 or 8 bits) for the communication port.
NOTE: This configuration option must be set to 8 if the communication port is used as the network communication link.
NOTE: This configuration option is not available if the communication port is configured for synchronous operation.
CParity: None
Next None Even Odd
Communication Port Parity. Configures the parity (none, even, or odd) for the communication port.
NOTE: This configuration option is not available if the communication port is configured for synchronous operation.
CStop Bits: 1
Next 1 1.5 2 Prev
Communication Port Stop Bits. Configures the number of stop bits (1, 1.5, or 2) for the communication port.
NOTE: This configuration option is not available if the communication port is configured for synchronous operation.
Ignore DTR: No
Next Yes No Prev
Communication Port Ignore DTR State. Specifies whether the CSU ignores the state of the Data Terminal Ready (DTR)
input to the communication port.
Yes – DTR is ignored.
No – DTR is not ignored.
NOTE: This configuration option is not available if the communication port is configured for synchronous operation.
CmInActTm: Disab
Next Enab Disab Prev
Communication Port Inactivity Timeout. Specifies whether the communication port disconnects after a period of inactivity
specified by the CmDiscTm configuration option.
Enab – The communication port disconnects after the period of inactivity specified by the CmDiscTm configuration option.
Disab – The communication port does not disconnect due to inactivity.
3150-A2-GB21-80
User Interface Configuration Options
9.6 14.4 19.2 38.4
Prev
Table C-4
(5 of 8)
Prev
February 1998
Configuration Options
C-11