Table of Contents
Advertisement
Dentsply Sirona
Instructions for Use Treatment Center Axano Pure
68 29 514 D3685
D3685.201.02.01.02 2023-12
4
Operation
4.1
Starting up the treatment center
4.1.1
Switching the treatment center on/off
The treatment center is equipped with a standby system for enhanced
convenience when switching it on and off at the dentist element.
The treatment center therefore has a power switch at the base of the
chair and a standby switch at the dentist element.
4.1.1.1
Power switch
The power switch connects the treatment center to the power supply.
During longer periods of disuse, the treatment center should be
disconnected from the power supply. It then no longer consumes any
energy.
IMPORTANT
System and data security after a hard shutdown via the power switch
or central shutdown
It is generally recommended to switch off the center via the standby
switch on the dentist element. Only this allows data to be
systematically backed up and systems shut down in an orderly
manner.
Hard shutdown can lead to loss of data or integrity errors in the
system. After switching on again, a recovery process is started to
restore system integrity.
Connecting the treatment center to the power supply
ü The treatment center is installed by authorized technical personnel
according to the "Installation instructions".
➢ Turn on the power switch (A).
Ä The treatment center is connected to the power supply.
Disconnecting the treatment center from the power supply
ü The treatment center is powered down, see "Standby switch"
[→ 49].
➢ Turn off the power switch (A).
Ä The treatment center is disconnected from the power supply.
4.1.1.2
Standby switch
Switching the treatment center on
The standby switch switches the treatment center from standby mode to
operational readiness.
After switching it on, the operating system is booted and an automatic
self-test is conducted.
4 Operation
4.1 Starting up the treatment center
49
Advertisement
Table of Contents
