Foot Control And Connection Box; Changing The Battery Of The Wireless Foot Control - Dentsply Sirona Treatment Center Axano Pure Instructions For Use Manual

5 Care, cleaning and maintenance by the practice team

5.7 Foot control and connection box

266
5.7 Foot control and connection box
5.7.1

Changing the battery of the wireless foot control

The wireless foot control is powered by a battery. An empty battery is
detected and reported by the system. The battery can be replaced by
the user.
For the battery type, see "Spare parts and consumables" [→ 271].
➢ Switch the treatment center off at the standby switch before
changing the battery. This prevents the inadvertent triggering of
unwanted functions.
Changing the battery of the Smart Control
1. Open the battery cover with a pen or screwdriver.
2. Take the battery out of the battery compartment and replace it with
a new one. Be careful to insert it with the correct polarity.
3. Note the flashing signal of the LED after replacing the battery, see
"Check battery" (below).
4. Close the battery cover.
Changing the battery of the Classic foot control
The housing of the wireless foot control must be opened to change the
battery. Touch a grounded metal part before opening the housing to
prevent damage to the PC board due to electrostatic discharge.
Instructions for Use Treatment Center Axano Pure
D3685.201.02.01.02 2023-12
Dentsply Sirona
68 29 514 D3685